Coomassie Stain solution

Coomassie Stain solution Destain solution : direction:
1) Remove SDS-PAGE gel from glass and rinse once in ddH2O in a suitable container with a lid. Try not to use a container much larger or much smaller then the gel.
2) Add enough Coomassie Stain to cover the gel by 1/2 inch (~ 1.5 cm).
3) Microwave on high power for 40 seconds to 1 minute (until the Coomassie Stain boils).
4) Incubate the gel in the Coomassie stain for 5 to 10 minutes on a rocking table. If you did not microwave the Coomassie/gel, incubate for at least 1 hour.
5) Pour off the Coomassie Stain. The Coomassie Stain can be recycled a couple of times by filtering it.
6) Rinse twice in ddH2O or used Destain solution to remove Coomassie Stain from the container.
7) Add fresh Destain solution to cover the gel by 3/4 inch (~ 2 cm).
8) Tie Kimwipes in a simple knot and place 4 of them in the Destain solution around the gel. Try to avoid laying the Kimwipes on the gel as this will cause an uneven destaining.
9) Microwave on high power for 40 seconds to 1 minute (until the Destain boils).
10) Incubate the gel in the Destain solution for 10 minutes on a rocking table. If you did not microwave the Coomassie/gel, incubate for at least 1 hour.
11) Discard the stained Kimwipes and replace with fresh knotted Kimwipes.
12) Incubate a second time for 10 minutes to overnight on a rocking table. Stop whenever the level of destaining is sufficient for you. Microwave again to speed up the process.
13) The used Destain solution can be recycled a couple of times by storing it in a sealed .

From:http://www.genetic-tests.net/readytouse-reagents/63/